![]() Restart Apache server and check it is already enabled: $ sudo /opt/bitnami/ctlscript.sh restart apache ![]() LoadModule ldap_module modules/mod_ldap.so LoadModule authnz_ldap_module modules/mod_authnz_ldap.so Uncomment the mod_authnz_ldap line and add the mod_ldap line at the end of the LoadModule section. Edit the main Apache configuration file located at /opt/bitnami/apache2/conf/nf. To enable this module, follow these steps:Įnable the LDAP module. LDAPīitnami stacks already ship the LDAP module installed in Apache but it is not enabled by default. Refer to the FAQ for more information on these changes. The output of the command indicates which approach (A or B) is used by the installation, and will allow you to identify the paths, configuration and commands to use in this guide. To identify your Bitnami installation type and what approach to follow, run the command below: $ test ! -f "/opt/bitnami/common/bin/openssl" & echo "Approach A: Using system packages." || echo "Approach B: Self-contained installation." ![]() On account of these changes, the file paths stated in this guide may change depending on whether your Bitnami stack uses native Linux system packages (Approach A), or if it is a self-contained installation (Approach B). ![]() NOTE: We are in the process of modifying the file structure and configuration for many Bitnami stacks. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |